Active Consistuent: Sodium Bicarbonate 

General Instructions:

1. Test for total alkalinity with a reliable test kit using fresh testing reagents & if necessary make the adjustment according to the directions for use.
2. pH buffer should be dissolved in a bucket of water and dispersed around the pool or spa.
3. Run the filter whilst adding pH Buffer to ensure adequate distribution throughout the pool or spa water.
4. Allow 3-4 hours before testing the total alkalinity level again. Make further additions if necessary using the dosage rate as a guide.

Note: pH BUFFER (Sodium Bicarbonate) is used to raise total alkalinity levels in swimming pool and spa water to 'buffer' the pH. If total alkalinity levels are too low, pH 'bounce' (or excessive fluctuations) will occur.

The minimum total alkalinity level in a pool or spa should be 60mg/L (p.p.m)

Direction for Use:

MSDS: https://www.poolpro.com.au/images/stories/virtuemart/product/buffer_all-grades17.pdf